Signal Generator

The R&S SMATE200A is based on the successful R&S SMU200A but is specifically designed to meet production requirements. It comes without a display or keys on the front panel, and its connectors are located at the rear. In addition, it is optimized for faster setting times in order to reduce test time.Features：Very short setting times for frequency and level (<3 ms) In List mode, setting time reduced down to <400 µs through use of predefined frequency and level valuesFlexibly addressable Fast Hop mode with setting times same as in List modeMultisegment waveform function enables fast switching between different test signals in basebandElectronic attenuator for entire frequency and level rangeStatus LEDs on front, connectors on rearÜVery low SSB phase noise of typ. 135 dBc, or typ. 140 dBc with the Low Phase Noise option (20 kHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)Wideband noise of typ. 153 dBc (>5 MHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)High output power of typ. +26 dBm with High-Power Output optionVery high level repeatability of typ. 0.05 dBI/Q modulator with 200 MHz system bandwidthExcellent ACLR performance of typ. +70 dB with 3GPP FDDÜUp to two complete independent signal generators in one unitChoice of 3 GHz and 6 GHz frequency options in both pathsUp to two independent baseband sources that not only support realtime signal generation but also offer arbitrary waveform generation with up to 64 Msamples eachÜDigital Standard Eutra/LTE availableRemote-controllable via LAN (Gigabit Ethernet) and GPIB