ACTERNA OLP-15C光功率计操作流程
Published on2026-03-31
ACTERNA OLP-15C光功率计操作流程主要包括准备、连接、设置波长、读取结果等关键步骤，适用于光纤链路测试与损耗评估 。准备工作确保具备以下条件：发光光源（如设备光口或传输光路）匹配接头的测试光纤（如FC/PC接口），必要时配备转换器光衰减器（用于高功率场景，防止损坏设备）已充电或装有电池的ACTERNA OLP-15C光功率计连接设备若不确定光功率是否过高，建议先将光衰减器接入光源端或光功率计输入端使用测试光纤将光源与光功率计的IN口（输入口）连接打开光功率计电源开关设置波长按“λ/+”键选择与光源匹配的测试波长（常见校准点包括850nm、1300nm、1310nm、1490nm、1550nm、1625nm）确保波长设置准确，以保证测量精度读取测量值屏幕显示当前光功率值（单位通常为dBm或W，可通过“dBm/W REL”键切换）若使用了光衰减器，最终光功率 = 显示值 + 衰减值如测得数值较高（如>-15dBm），建议取下光衰后重新测试以提高准确性附加功能（如适用）使用“SAVE/-”键保存测量数据使用“DET”键删除历史记录在光源模式下，可通过“LD”键切换并输出指定波长光信号（需使用OUT口）
Key Words：ACTERNA OLP-15COLP-15COLP-15C光功率计
Copyright and Disclaimer
1.This website reprints content from external sources (not from Shenzhen Haochen Electronic Technology) and clearly indicates the original source. The purpose of such reproduction is for informational exchange only and does not imply endorsement of the views expressed therein, nor does it assume responsibility for the accuracy or authenticity of the content. The website shall not bear any direct or joint liability for infringement arising from the use of such materials.
2.Any media outlets, websites, or individuals reprinting content from this website must retain the original source attribution as specified herein and assume full legal responsibility for copyright compliance and any related intellectual property matters.
3.If the article involves issues such as content or copyright, you may contact the publisher to offer your opinions or request its removal. Alternatively, you need to contact us within one week from the date of publication. Otherwise, it will be regarded as the waiver of relevant rights.